Boss MR1004

4 x 38W RMS 4 Ohm
Läs mer


Pris




Riot 400W 4 Channel Full Range, Class A/B Amplifier

  • Weather Proof 400 W MAX Power 4 Channel
    75 W X 4 RMS @ 2 ohm
    38 W X 4 RMS @ 4 ohm
  • Full Range, Class A/B,
  • High and Low Level Inputs


2 Ohm Stable

The lowest impedance accepted by this amplifier is 2 ohms. Amplifiers that are 2 ohms stable produce more power resulting in more volume. This amp can comfortably power speakers or subwoofers with all channel(s) being used at a load of 2 ohms.

 

Class A/B

Class A/B amplifiers have long been known for their ability to produce great quality sound while performing more efficiently than pure Class A amplifiers. We have developed a specific linear circuitry that further reduces distortion while increasing both sound quality and power output.

 

Fully Marinized

Fully Marinized is the term we use for our Marine and Outdoor products that are Weather Proof. We integrate high-tech, state-of-the-art waterproofing materials plus special UV coatings for plastic surfaces, coated circuit boards and connections to protect the product against the harsh outdoor elements and resist corrosion.

 

High and Low Level Inputs

An amplifier with both high-level and low-level inputs provides flexibility by allowing you to build an audio system using virtually any standard factory or aftermarket source unit. High-level (speaker level) inputs accept the signal from the speakers, while low-level (RCA) inputs accept the signal from the pre-amp outputs of the source unit.

 

Protection

If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.

 

Variable Gain Control

Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping.

 

General Specs

AMP TOPOLOGY
Full Range, Class A/B
CHANNEL CONFIGURATION
4 Channel

Performance Specs

TOTAL POWER OUTPUT
400 Watts
PEAK POWER @ 2 Ω
100 Watts x 4
PEAK POWER @ 4 Ω
50 Watts x 4
RMS POWER @ 2 Ω
75 Watts x 4
RMS POWER @ 4 Ω
38 Watts x 4
SPEAKER IMPEDANCE
2 to 8 Ω
T.H.D. (TOTAL HARMONIC DISTORTION)
0.01 %
CHANNEL SEPARATION ≥
60 dB
S/N RATIO (A-WEIGHTED)
90 dB
FREQUENCY RESPONSE
12 Hz to 22 kHz ±1 dB

Connections, Controls, and Processing

RCA INPUTS
4 Channel
HIGH LEVEL INPUTS
THERMAL/OVERLOAD/SHORT PROTECTION

Measurement

LENGTH
7.75"
WIDTH
9"
HEIGHT
2"

Extra Features

Weather Proof
  • Antal artiklar: {{ cart.count }} st
  • Totalt: {{ cart.formattedTotalWithDiscount }}
Gå till kassan