Boss PD5000

1 x 3750W RMS 1 Ohm
3 495 kr (4 495 kr) Svea webpay delbetala Delbetala från 199 kr/mån
Artikelnr: PD5000
Lagerstatus:
I Lager

Phantom 5000W Monoblock, Class D Amplifier

  • 5000 W MAX Power 1 Channel
    3750 W X 1 RMS @ 1 ohm
    1875 W X 1 RMS @ 2 ohm
    938 W X 1 RMS @ 4 ohm
    7500 W X 1 RMS Strapped Bridged Power @ 2 ohm
  • Monoblock, Class D, MOSFET Power Supply
  • Low Level Inputs, RCA Pre-amp Outputs
  • Variable Low Pass Crossover, Variable Bass Boost and Variable Subsonic Filter and Switchable Phase Control
  • Include Remote Subwoofer Control
  • Red LED Backlit Illumination

 

1 Ohm Stable

The lowest impedance accepted by this amplifier is 1 ohm. Amplifiers that are 1 ohm stable produce the most power possible from the amp. An amplifier capable of delivering power at a 1 ohm load is usually reserved for serious subwoofers that can handle the power. Please note this particular amp needs a healthy electrical system including a low gauge wire capable of delivering the necessary current.

 

Class D Amps

Class D is a high speed switching amplifier technology that is more efficient, generates less heat and draws less power than traditional Class A/B amps. We use Class D in our monoblock amplifiers to give you massive amounts of power in a relatively small footprint for clean, powerful, bass.

 

Multi LED Back Lit

Multiple LED Backlighting gives this Phantom Series Amps an awsome red glow when the amp is turned on.

 

Phase Control

The phase control feature allows you to adjust the speakers phase to ensure all audio signals are playing together rather than against each other. When bass notes are noticeably absent, a quick and easy adjustment to the phase control could provide the perfect remedy.

 

Protection

If the amplifier gets too hot, the thermal protection circuit turns the amp off and allows the amp to cool down before turning it back on. If a speaker fails causing an electrical short, the protection circuit will automatically cut the output and remain in that state until the short is resolved. These safety features give you peace of mind knowing the amplifier is constantly monitoring conditions to protect itself.

 

Strapping Capability

Strapping capability means that two amplifiers can be linked together to create double the power at an impedance of 2 ohms. A benefit of strapping is less electrical current is required than if you ran [2] individual amps at 1 ohm and you only need 1 pair of preamp outputs and [1] RCA cable to connect.

 

Subsonic Filter

A subsonic filter is designed for use on subwoofers. Since not all subwoofers can reproduce the same low frequencies, the subsonic filter can be set for optimum bass response in order to keep the driver playing efficiently.

 

Subwoofer Level Control

The ability to boost or attenuate the sub level when an amp and subwoofer are connected to the subwoofer pre-amp output.

 

Switchable Input Sensitivity

Switchable Input Sensitivity gives you the freedom to connect the amp to any standard source unit and have peace of mind it will be within range to properly match the output of the source unit allowing you to use the volume controls on your source unit the way it was designed.

 

Variable Bass Boost

Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it.

 

Variable Gain Control

Variable Gain Control lets you balance the amps output with the speakers or subs the amp is driving. To much gain will lead to distortion and to little will lead to clipping.

 

Variable Low Pass Filter

Variable low-pass filter gives you control over the frequencies that pass through to the subwoofer.

 

General Specs

AMP TOPOLOGY
Monoblock, Class D
CHANNEL CONFIGURATION
1 Channel
POWER SUPPLY TYPE
MOSFET Power Supply

Performance Specs

TOTAL POWER OUTPUT
5000 Watts
PEAK POWER @ 1 Ω
5000 Watts x 1
PEAK POWER @ 2 Ω
2500 Watts x 1
PEAK POWER @ 4 Ω
1250 Watts x 1
RMS POWER @ 1 Ω
3750 Watts x 1
RMS POWER @ 2 Ω
1875 Watts x 1
RMS POWER @ 4 Ω
938 Watts x 1
STRAPPED POWER BRIDGED @ 2 Ω
10000 Watts
SPEAKER IMPEDANCE
1 to 8 Ω
T.H.D. (TOTAL HARMONIC DISTORTION)
0.01 %
S/N RATIO (A-WEIGHTED)
100 dB
FREQUENCY RESPONSE
15 Hz to 150 Hz ±1 dB

Connections, Controls, and Processing

RCA INPUTS
2 Channel
PRE AMP OUTPUTS
2 Channel
LOW PASS FILTER
50 Hz to 150 Hz
SUBSONIC FILTER
15 Hz to 40 Hz
BASS BOOST
Variable 0 to 18 dB
SWITCHABLE PHASE CONTROL
0 to 180°
SUBWOOFER LEVEL CONTROL
INPUT SENSITIVITY SWITCH
STRAPPABLE
THERMAL/OVERLOAD/SHORT PROTECTION

Measurement

LENGTH
18"
WIDTH
10.31"
HEIGHT
2.25"
Ditt namn:
Din e-post:
Din väns e-post:

Relaterade produkter

Ampire MB400.1-2G
Ampire MB400.1-2G
1 x 400W RMS 2 Ohm
1 195 kr 1 495 kr
Boss PD3000
Boss PD3000
1 x 2250W RMS 1 Ohm
1 995 kr 2 995 kr
Ampire MBM500.1-2G
Ampire MBM500.1-2G
1 x 500W RMS 2 Ohm kompakt design
1 995 kr
Ampire MdB3000.1
Ampire MdB3000.1
1 x 3000W RMS 1 Ohm
5 995 kr
Ampire MB1000.1-2G
Ampire MB1000.1-2G
1 x 1000W RMS 1 Ohm
1 995 kr
Ampire MMX1
Ampire MMX1
1 x 400W RMS 2 Ohm ultra kompakt design
1 995 kr 2 495 kr